Schwinn 125 Owner's Manual download pdf (Page 29)

CONSOLE SETUp MOdE

The Console Setup Mode lets you set the units of measure to either English or Metric, change the machine type, or see

maintenancestatistics(ErrorLogandRunHours–forservicetechnicianuseonly).

1. Hold down the Increase button and Decrease button together for 3 seconds while in the Power-Up Mode to go into the

Console Setup Mode.

Note: Push START/STOP to go back to the previous screen or the Power-Up Mode screen.

2. The Console display shows the Units prompt. Push ENTER to start Units option. Push the Increase/Decrease buttons to

changebetween“Miles-Lb”(Englishunits)and“Km-Kg”(metricunits).

Note: If the units change when there is data in User Statistics, the statistics change to the new units.

3. PushENTERtoset.Forthenextoption,pushtheIncreasebutton.

4. The Console display shows the Machine Type prompt. Push ENTER to start Machine Type option. Push the Increase/

DecreasebuttonstochangebetweenELLIPTICALandBIKE.

5. PushENTERtoset.Forthenextoption,pushtheIncreasebutton.

6. The Console display shows the Error Log prompt. Push ENTER to start Error Log option. The Error Log stores the last 10

errors (error type and system time of error), listed newest to oldest. Push the Increase/Decrease buttons to move through

theErrorLog.Iftherearenoerrors,theConsoledisplayshows“Index=0”.

7. PushSTART/STOPtoexit.Forthenextoption,pushtheIncreasebutton.

8. The Console shows the Run Hours prompt. Push ENTER to see total hours for the machine.

9. PushSTART/STOPtoexit.Forthenextoption,pushtheIncreasebutton.

10. The Console display shows the Units prompt again. Push START/STOP to go back to the Power-Up Mode screen.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

No comments

Schwinn 125 Owner's Manual Page 29