Schwinn 220(2012 model) Owner's Manual download pdf (Page 33)

The Console Setup Mode lets you set the units of measure to either English or Metric, change the

machine type, or see maintenance statistics (Error Log and Run Hours – for service technician use

only).

1. Hold down the Increase button and Decrease button together for 3 seconds while in the

POWER-UP MODE to go into the CONSOLE SETUP MODE.

Note: Push STOP to go back to the previous screen or the Power-Up Mode screen.

2. The Console display shows the Units prompt. Push START/ENTER to start Units option. Push

theIncrease/Decreasebuttonstochangebetween“Miles-Lb”(Englishunits)and“Km-Kg”

(metric units).

Note: If the units change when there is data in User Statistics, the statistics change to the new

units.

3. Push START/ENTER to set.

4. The Console display shows the Machine Type prompt. Push START/ENTER to start Machine

Typeoption.PushtheIncrease/DecreasebuttonstochangebetweenELLIPTICALandBIKE.

5. Push START/ENTER to set.

6. The Console display shows the Error Log prompt. Push START/ENTER to start Error Log

option. The Error Log stores the last 10 errors (error type and system time of error), listed

newest to oldest. Push the Increase/Decrease buttons to move through the Error Log. If there

arenoerrors,theConsoledisplayshows“Index=0”.

7. PushSTOPtoexit.

8. The Console shows the RUN HOURS prompt. Push START/ENTER to see total hours for the

machine.

9. PushSTOPtoexit.

10. The Console display shows the Units prompt again. Push STOP to go back to the Power-Up

Mode screen.

CONSOLE SETUp MODE

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Schwinn 220(2012 model) Owner's Manual Page 33